Conventions for this Help file of HELGA :


  • the whole concept of SPORTident, including the settings of the controls must be mastered and have been configured before starting HELGA - (to do this, it's recommended to use the software "SI-Config+ " available on the SPORTident website),

  • including the synchronisation of each control (SI-Config+ / SI-Master station)
  • the reading unit (BSM 8) must be configured in "extended protocol" (i.e. ) (via SI-Config+)
  • With the exception of a use as Online Control, the check-box "Autosend" must remain unchecked.
  • N.B. the analysis of an SI-card 6 with the configuration 192 punches is done without any specific parameter inside HELGA.




  • The given explanations are most of the time valid for both systems of electronic timing.  As an example, the buttons

and ,

and

are identical commands, whatever the displayed help screen.


  • To the contrary, if you see within the text a table like , it means that the given explanations will depend on the used E-system.

  • To maintain the most readable screens, we set as "non visible" (in the alternate E-system) any typical options of one system.  (e.g. all the informations related to the "back-up tickets" of EMIT are not used with SPORTident.

  • The Help file about SPORTident is just starting and will be optimized after several uses "on the field".  Don't hesitate to contact the Helpdesk to ask precisions, or the updating on the help file according your experiences.

Copyright © <2007 +>,<Robert Marique - Michael Hock>